Service of the Infiniti QX4 since 1996 of release
1. Introduction
2. Maintenance instruction
3. Routine maintenance
4. Engine
5. Cooling system and heating
6. Feed and control systems
7. Systems of start and charge
8. Transmission line
9. Brake system
10. Suspension bracket and steering
11. Body
12. Electric equipment
12.1. Specifications
12.2. Search of causes of failures of electric equipment
12.3. Electric sockets - general information
12.4. Safety locks and fusible inserts - the general information
12.5. Chain breakers - the general information
12.6. The relay - the general information and check of serviceability of functioning
12.7. Check of serviceability of functioning and replacement of the breaker of indexes of turns / alarm system
12.8. Replacement of lamps of lighting fixtures
12.9. Check of serviceability of functioning and recovery repair of a heater of back glass
12:10. System of additional safety (SRS)
12:11. Schemes of electric connections
 














12-8-zamena-lamp-osvetitelnykh-priborov.html

12.8. Replacement of lamps of lighting fixtures


Replacement of lamps of head headlights

When replacing any lamp, pay attention to the next moments:

  • Remember that flasks of lamps remain hot within about 20 minutes after shutdown of lighting fixtures. Before getting to work make sure that components finally cooled down;
  • Flasks of lamps of halogen and xenon type are filled with the gas which is under pressure and at sharp stirring can blow up. Try to take such lamps only for a socle and use goggles. Remember that at a flask contact with naked fingers on glass there are fatty spots that leads to a premature exit of a lamp out of operation as a result of an overheat. Before installation wipe a lamp flask with alcohol;
  • Always check a condition of socles of lamps and contacts of cartridges, before installation of a lamp without fail smooth out contact surfaces, completely deleting from them dirt and traces of corrosion;
  • You watch that the replaceable lamp in accuracy corresponded failed according to the electric characteristics (supply voltage and power).

On the Infiniti QX4 models block headlights of semi-tight type with replaceable halogen lamps are used.

 PERFORMANCE ORDER

  1. Disconnect a negative wire from the battery.
  2. Disconnect the electrical wiring brought to back the parties of a lamp (see the illustration Replacement of Lamps of Head Headlights).
  3. Having pulled, remove a rubber protective cover of a block headlight (see the illustration Replacement of Lamps of Head Headlights).
  4. Wring out and develop a lock uvula.
  5. Take a lamp from assembly of a block headlight (see the illustration Replacement of Lamps of Head Headlights).
  6. Installation is made upside-down.


Other lamps

The replacement procedure of lamps of other lighting fixtures is given in illustrations:


Extraction order from cartridges of lamps of various types used on the Infiniti QX4 models


Scheme of an arrangement of onboard lighting fixtures


Replacement of lamps of lighting fixtures




Replacement of a lamp of illumination of a toilet pocket mirror


"on the page back
12.7. Check of serviceability of functioning and replacement of the breaker of indexes of turns / alarm system
on the following page"
12.9. Check of serviceability of functioning and recovery repair of a heater of back glass