Service of the Infiniti QX4 since 1996 of release
	1. Introduction
	2. Maintenance instruction
	3. Routine maintenance
	4. Engine
	5. Cooling system and heating
	6. Feed and control systems
	7. Systems of start and charge
	8. Transmission line
		8.1. 4-staged automatic transmission
			8.1.1. General information
			8.1.2. Failure diagnostics of AT - the general information
			8.1.3. Electronic and hydraulic control system of 4-staged AT
			8.1.4. Removal and installation of transmission
			8.1.5. Replacement of an epiploon of lengthening of transmission
			8.1.6. Removal and installation of a cooler of ATF
			8.1.7. Removal and installation of valvate assembly of a hydraulic contour of management of AT
			8.1.8. Removal, check of a state and installation of a driving cable of blocking of switchings
			8.1.9. Adjustment of the drive of switching of AT
			8.1.10. Adjustment of the sensor switch of provisions of AT/permission of start
			8.1.11. Capital repairs of AT
		8.2. Transfer case
		8.3. Differentials, power shafts / half shafts
		8.4. Driveshafts
	9. Brake system
	10. Suspension bracket and steering
	11. Body
	12. Electric equipment

8-1-10-regulirovka-datchika-vyklyuchatelya-polozhenijj-at-razresheniya-zapuska.html

8.1.10. Adjustment of the sensor switch of provisions of AT/permission of start

PERFORMANCE ORDER

Disconnect driving draft from the lever a shaft of manual switching of AT. Transfer the lever of a shaft of manual switching to situation "N".
Release fixture of the sensor switch of permission of start.
Pass a suitable pin through an opening in the lever of a shaft of manual switching and the sensor switch of permission of start — the lever has to hold closer to vertical position.
Install into place the being removed components and check serviceability of functioning of the sensor switch of permission of start — start of transmission has to be carried out only in provisions "P" or "N" of the lever of the selector.