Service of the Infiniti QX4 since 1996 of release
1. Introduction
2. Maintenance instruction
3. Routine maintenance
4. Engine
5. Cooling system and heating
6. Feed and control systems
7. Systems of start and charge
8. Transmission line
9. Brake system
10. Suspension bracket and steering
11. Body
11.1. Wash of the car
11.2. Care of body elements and paint and varnish covering
11.3. Care of vinyl elements of finishing
11.4. Care of the chromeplated finishing elements
11.5. Care of cast aluminum disks
11.6. Care of upholstery elements, carpets of salon and seat belts
11.7. Repair of insignificant damages of body panels
11.8. Repair of seriously damaged body panels
11.9. Service of loops and locks of the car
12. Electric equipment
 














11-1-mojjka-avtomobilya.html

11.1. Wash of the car

In the listed below cases the car should be subjected immediately to drive away on a sink:

  • After hit under a rain which in a modern ecological situation quite may contain acid;
  • After a trip in coastal areas;
  • At hit on a paint and varnish covering of soot, a bird's dung, wood pitch, remains of insects and metal dust;
  • At emergence of a road film.

Whenever possible try to keep the car in the covered garage.

At the parking on the street try that the car whenever possible remained in the shadow.

When drawing sheetings try not to allow damages of LKP!

When performing a wash of the car by own forces first of all, as far as possible, it is necessary to bring down the stuck dirt and a dust layer a water stream under pressure, then a damp sponge carefully to remove the remains of pollution. For a fair sink use patent cleaners, or weak solution of soap in warm (not more hotly!) to water. In conclusion rinse a body surface with plentiful amount of clear water.

Do not forget to wash away also dirt from the bottom of the car and internal surfaces of wheel arches.

Having finished a sink, carefully wipe the painted body elements with pure soft rags, having completely removed from them moisture traces.

In bendings of flanges, cavities of seams, folds of body panels, loops of doors and a cowl, etc. places always accumulate containing the adjournment salt applied to processing of a paving in view of what they should be cleaned regularly carefully. You watch that passability of drainage openings in bottom edges of door assemblies was not broken.


"on the page back
11. Body
on the following page"
11.2. Care of body elements and paint and varnish covering