Service of the Infiniti QX4 since 1996 of release
1. Introduction
2. Maintenance instruction
3. Routine maintenance
4. Engine
5. Cooling system and heating
6. Feed and control systems
7. Systems of start and charge
8. Transmission line
8.1. 4-staged automatic transmission
8.1.1. General information
8.1.2. Failure diagnostics of AT - the general information
8.1.3. Electronic and hydraulic control system of 4-staged AT
8.1.4. Removal and installation of transmission
8.1.5. Replacement of an epiploon of lengthening of transmission
8.1.6. Removal and installation of a cooler of ATF
8.1.7. Removal and installation of valvate assembly of a hydraulic contour of management of AT
8.1.8. Removal, check of a state and installation of a driving cable of blocking of switchings
8.1.9. Adjustment of the drive of switching of AT
8.1.10. Adjustment of the sensor switch of provisions of AT/permission of start
8.1.11. Capital repairs of AT
8.2. Transfer case
8.3. Differentials, power shafts / half shafts
8.4. Driveshafts
9. Brake system
10. Suspension bracket and steering
11. Body
12. Electric equipment
 














8-1-9-regulirovka-privoda-pereklyucheniya-at.html

8.1.9. Adjustment of the drive of switching of AT

 PERFORMANCE ORDER

  1. Transfer the selector lever from situation "P" to situation "1", - pass of each tooth has to be defined distinctly to the touch, otherwise, and also in case of failure of the index of position of the lever, make necessary adjustment of the drive.
  1. Return the lever to situation "P", then release lock-nuts of the coupling coupling.
  1. Having delayed the selector lever towards situation "R" (without squeezing of the button), rotation of the coupling coupling try to achieve combination it with the cable core.
  1. Release the coupling on one turn and tighten lock-nuts with the required effort. (4.4 — 5.9 Nanometer).
  1. Having transferred the selector lever to situation "1", make sure of smoothness of its movement.


"on the page back
8.1.8. Removal, check of a state and installation of a driving cable of blocking of switchings
on the following page"
8.1.10. Adjustment of the sensor switch of provisions of AT/permission of start