Service of the Infiniti QX4 since 1996 of release
	1. Introduction
	2. Maintenance instruction
	3. Routine maintenance
	4. Engine
	5. Cooling system and heating
	6. Feed and control systems
	7. Systems of start and charge
	8. Transmission line
		8.1. 4-staged automatic transmission
		8.2. Transfer case
			8.2.1. General information
			8.2.2. Removal and installation of the transfer case
			8.2.3. Removal and installation of a driving electric motor of the actuation mechanism of the transfer case
			8.2.4. Replacement of an oil filter of the transfer case
			8.2.5. Replacement of epiploons of an output shaft of the transfer case
			8.2.6. Replacement of an epiploon of a rod of switching of the transfer case
		8.3. Differentials, power shafts / half shafts
		8.4. Driveshafts
	9. Brake system
	10. Suspension bracket and steering
	11. Body
	12. Electric equipment

8-2-2-snyatie-i-ustanovka-razdatochnojj-korobki.html

8.2.2. Removal and installation of the transfer case

The description is provided for models with lever switching of the modes.

PERFORMANCE ORDER

Remove forward and back sections of system of production of the fulfilled gases. Remove forward and back driveshafts (see Removal and installation of driveshafts) — at once after removal of a back shaft muffle an opening of a back epiploon in order to avoid hit in dirt assembly. Try not to damage an epiploon, walls of its landing nest and a pin of the sliding collar. Disconnect an electrical wiring of sensors switches of provisions (N-4LO and Pacific Rim) and switchings of the modes of the transfer case, forward RPM meter, and an executive electric motor.
Disconnect a control lever switching from the external executive lever.
Prop up the transfer case a transmission jack.
Release fixture and separate a box from assembly of AT.
Installation is made upside-down. Track that all fixture was tightened with the required effort.