Service of the Infiniti QX4 since 1996 of release
1. Introduction
2. Maintenance instruction
3. Routine maintenance
4. Engine
5. Cooling system and heating
6. Feed and control systems
7. Systems of start and charge
8. Transmission line
8.1. 4-staged automatic transmission
8.2. Transfer case
8.2.1. General information
8.2.2. Removal and installation of the transfer case
8.2.3. Removal and installation of a driving electric motor of the actuation mechanism of the transfer case
8.2.4. Replacement of an oil filter of the transfer case
8.2.5. Replacement of epiploons of an output shaft of the transfer case
8.2.6. Replacement of an epiploon of a rod of switching of the transfer case
8.3. Differentials, power shafts / half shafts
8.4. Driveshafts
9. Brake system
10. Suspension bracket and steering
11. Body
12. Electric equipment
 







8-2-5-zamena-salnikov-vykhodnogo-vala-razdatochnojj-korobki.html

8.2.5. Replacement of epiploons of an output shaft of the transfer case

 PERFORMANCE ORDER

  1. Merge lubricant liquid from the transfer case.
  2. Remove forward section of system of production of the fulfilled gases and the thermofilter.
  3. Remove the forward driveshaft (see Removal and installation of driveshafts).
  1. By means of a special key release a lock-nut of a connecting flange.

The lock-nut is subject to replacement without fail.

  1. Mark with paint the provision of a connecting flange of rather carving pin.
  1. Remove a connecting flange by means of a stripper.
  1. Having used special adaptation take an epiploon from a forward casing.
  1. Establish a new epiploon, previously having greased its sealing sponges with universal lubricant.
  2. Establish a connecting flange.
  1. Tighten a lock-nut of a connecting flange with the required effort.
  1. Install the driveshaft.
  2. Installation of the remained components is made as it should be, the return to an order of their dismantle.


Back epiploon

 PERFORMANCE ORDER

  1. Remove the back driveshaft.
  2. Take a back epiploon from a landing nest in the case of the transfer case.
  1. Previously having greased sealing sponges with universal lubricant, put a new epiploon and press it in a nest by means of a cylindrical mandrel as which it is possible to use the replaceable face head suitable by the size or a piece of a pipe of the corresponding diameter. The edge of a mandrel has to rest only against a rigid face surface of an epiploon.
  1. Install into place the back driveshaft.

"on the page back
8.2.4. Replacement of an oil filter of the transfer case		 on the following page"
8.2.6. Replacement of an epiploon of a rod of switching of the transfer case