Service of the Infiniti QX4 since 1996 of release
1. Introduction
2. Maintenance instruction
3. Routine maintenance
4. Engine
5. Cooling system and heating
6. Feed and control systems
7. Systems of start and charge
8. Transmission line
9. Brake system
9.1. Specifications
9.2. System of anti-blocking of brakes (ABS) - the general information and codes of malfunctions
9.3. Check of a state and replacement of brake lines and hoses
9.4. Replacement of blocks of disk brake mechanisms of forward wheels
9.5. Removal and installation of a support of the disk brake mechanism
9.6. Removal and installation of a brake disk
9.7. Replacement of brake boots of drum brake mechanisms of back wheels
9.8. Removal and installation of the main brake cylinder (MBC)
9.9. Removal and installation of assembly of the vacuum amplifier of brakes
9.10. Pumping of the brake system
9.11. Adjustment of the drive of the parking brake
9.12. Adjustments of a pedal of a foot brake
9.13. Adjustment of a spring of the valve regulator (LSV), sensitive to loading
9.14. Adjustment of sensors switches of stoplights and tempostata
9.15. Removal and installation of the ABS hydromodulator
9.16. Removal and installation of the G-sensor
9.17. Check of serviceability of functioning of wheel ABS sensors
9.18. Check of serviceability of functioning of the G-sensor
9.19. Check of serviceability of functioning of the relay of a driving electric motor of the hydromodulator
9.20. Check of serviceability of functioning of the relay of the electromagnetic valve of the hydraulic ABS modulator
10. Suspension bracket and steering
11. Body
12. Electric equipment
 














9-14-regulirovka-datchikov-vyklyuchatelejj-stop-signalov-i-tempostata.html

9.14. Adjustment of sensors switches of stoplights and tempostata

Both sensors are located under the dashboard on an arm of a pedal of a foot brake (see an illustration Adjusting parameters of a pedal of a foot brake).

 PERFORMANCE ORDER

  1. Adjust height of situation and size of a free wheeling of a pedal of a foot brake (see Adjustments of a pedal of a foot brake).
  2. Measure gap size between the corresponding sensor and the lever of a pedal. The nominal rate makes 0.25 — 1.00 mm. In case of need release a lock-nut and make necessary adjustment by rotation of the sensor.
  3. Having finished adjustment, reliably tighten a lock-nut.

"on the page back
9.13. Adjustment of a spring of the valve regulator (LSV), sensitive to loading
on the following page"
9.15. Removal and installation of the ABS hydromodulator