Service of the Infiniti QX4 since 1996 of release
1. Introduction
2. Maintenance instruction
3. Routine maintenance
4. Engine
5. Cooling system and heating
6. Feed and control systems
7. Systems of start and charge
8. Transmission line
9. Brake system
9.1. Specifications
9.2. System of anti-blocking of brakes (ABS) - the general information and codes of malfunctions
9.3. Check of a state and replacement of brake lines and hoses
9.4. Replacement of blocks of disk brake mechanisms of forward wheels
9.5. Removal and installation of a support of the disk brake mechanism
9.6. Removal and installation of a brake disk
9.7. Replacement of brake boots of drum brake mechanisms of back wheels
9.8. Removal and installation of the main brake cylinder (MBC)
9.9. Removal and installation of assembly of the vacuum amplifier of brakes
9.10. Pumping of the brake system
9.11. Adjustment of the drive of the parking brake
9.12. Adjustments of a pedal of a foot brake
9.13. Adjustment of a spring of the valve regulator (LSV), sensitive to loading
9.14. Adjustment of sensors switches of stoplights and tempostata
9.15. Removal and installation of the ABS hydromodulator
9.16. Removal and installation of the G-sensor
9.17. Check of serviceability of functioning of wheel ABS sensors
9.18. Check of serviceability of functioning of the G-sensor
9.19. Check of serviceability of functioning of the relay of a driving electric motor of the hydromodulator
9.20. Check of serviceability of functioning of the relay of the electromagnetic valve of the hydraulic ABS modulator
10. Suspension bracket and steering
11. Body
12. Electric equipment
 







9-6-snyatie-i-ustanovka-tormoznogo-diska.html

9.6. Removal and installation of a brake disk

 PERFORMANCE ORDER

  1. The car also establish to Poddomkratta it on props (see the illustration Scheme of an Institution of Props for fixing of the car in the lifted situation). Remove the corresponding forward wheel.
  2. Remove a support of the brake mechanism (see Removal and installation of a support of the disk brake mechanism), without disconnecting from it the hydraulic line. Tie up a support a wire to suspension bracket elements — try not to allow tension of a brake hose.
  3. Uncover a stupichny nut.
  4. Give a bearing nut, remove a lock ring, a shpindelny, persistent and lock washer, turn off a stupichny nut remove a nave assembled with a brake disk.
  5. In case of need separate a disk from a nave.
  6. Installation is made upside-down.

"on the page back
9.5. Removal and installation of a support of the disk brake mechanism		 on the following page"
9.7. Replacement of brake boots of drum brake mechanisms of back wheels