Service of the Infiniti QX4 since 1996 of release
1. Introduction
2. Maintenance instruction
3. Routine maintenance
4. Engine
5. Cooling system and heating
6. Feed and control systems
7. Systems of start and charge
8. Transmission line
9. Brake system
9.1. Specifications
9.2. System of anti-blocking of brakes (ABS) - the general information and codes of malfunctions
9.3. Check of a state and replacement of brake lines and hoses
9.4. Replacement of blocks of disk brake mechanisms of forward wheels
9.5. Removal and installation of a support of the disk brake mechanism
9.6. Removal and installation of a brake disk
9.7. Replacement of brake boots of drum brake mechanisms of back wheels
9.8. Removal and installation of the main brake cylinder (MBC)
9.9. Removal and installation of assembly of the vacuum amplifier of brakes
9.10. Pumping of the brake system
9.11. Adjustment of the drive of the parking brake
9.12. Adjustments of a pedal of a foot brake
9.13. Adjustment of a spring of the valve regulator (LSV), sensitive to loading
9.14. Adjustment of sensors switches of stoplights and tempostata
9.15. Removal and installation of the ABS hydromodulator
9.16. Removal and installation of the G-sensor
9.17. Check of serviceability of functioning of wheel ABS sensors
9.18. Check of serviceability of functioning of the G-sensor
9.19. Check of serviceability of functioning of the relay of a driving electric motor of the hydromodulator
9.20. Check of serviceability of functioning of the relay of the electromagnetic valve of the hydraulic ABS modulator
10. Suspension bracket and steering
11. Body
12. Electric equipment
 







9-5-snyatie-i-ustanovka-supporta-diskovogo-tormoznogo-mekhanizma.html

9.5. Removal and installation of a support of the disk brake mechanism

 PERFORMANCE ORDER

  1. Car front also establish to Poddomkratta it on props (see the illustration Scheme of an Institution of Props for fixing of the car in the lifted situation). Remove the corresponding forward wheel.
  2. Disconnect from a support the brake line — at once to a zakuporta the open end of the line for the purpose of minimization of losses of brake fluid, and also in order to avoid hit in system of dirt.
  3. Turn out fixing bolts (see the illustration Design of Disk Brake Mechanisms of Forward Wheels) and remove a support.
  4. Installation is made upside-down — track that all fixture was tightened with the required effort.
  5. In conclusion pump over the brake system (see Pumping of the brake system).

"on the page back
9.4. Replacement of blocks of disk brake mechanisms of forward wheels		 on the following page"
9.6. Removal and installation of a brake disk