|
9-15-snyatie-i-ustanovka-gidromodulyatora-abs.html
9.15. Removal and installation of the ABS hydromodulator
|
|
- Disconnect a negative wire from the battery.
- Merge hydraulic liquid from brake lines.
- Mark adjusting position of lines and disconnect them from assembly of the hydromodulator (see the illustration Scheme of an Arrangement on the car of the ABS elements).
- Disconnect an electrical wiring from the modulator.
- Give three fixing nuts and remove assembly of the hydromodulator.
- Without tightening nipple sockets connect hydraulic lines to the modulator.
- Establish assembly of the modulator on the regular place and tighten fixing nuts.
- Tighten nipple sockets of brake lines with the required effort.
- In conclusion add necessary amount of hydraulic liquid of the required grade in the GTTs tank and pump over the brake system (see Pumping of the brake system).
|
|
|
|