Service of the Infiniti QX4 since 1996 of release
1. Introduction
2. Maintenance instruction
3. Routine maintenance
4. Engine
5. Cooling system and heating
6. Feed and control systems
7. Systems of start and charge
8. Transmission line
9. Brake system
10. Suspension bracket and steering
10.1. Specifications
10.2. Assessment of the general condition of components of a suspension bracket and steering of the car
10.3. Check of a state and replacement of spherical support of a forward suspension bracket
10.4. Check of a condition of steering drafts
10.5. Removal and installation of the cross lever of a forward suspension bracket
10.6. Adjustment of a pretightness of stupichny bearings of forward wheels
10.7. Removal, check of a state and installation of screw springs and rack-mount assemblies of a forward suspension bracket
10.8. Removal and installation of stupichny assembly and rotary fist
10.9. Removal, check of a state and installation of the forward stabilizer of cross stability
10:10. Replacement of stupichny bearings
10:11. Check of a condition of shock-absorbers and springs of a back suspension bracket
10:12. Removal and installation of components and assembly of a back suspension bracket
10:13. Removal, check of a state and installation of levers of a back suspension bracket
10:14. Removal, check of a state and installation of screw springs of a back suspension bracket
10:15. Removal and installation of shock-absorbers of a back suspension bracket
10:16. Removal and installation of the back stabilizer of cross stability
10:17. Removal, check of a state and installation of a cross jet bar of a back suspension bracket
10:18. Pumping of a hydraulic path of the steering drive
10:19. Checks and adjustments of a steering wheel
10:20. Check of effort of resistance to sliding of a lath of the steering mechanism
10:21. Adjustment of torque of a provorachivaniye of the leading gear wheel of the steering mechanism
10:22. Check of hydraulic pressure of GUR
10:23. Adjustment of effort of a tension of a belt of the drive of the steering pump
10:24. Removal and installation of reduktorny assembly
10:25. Removal and installation of assembly of the steering mechanism
10:26. Removal and installation of the steering pump
10:27. Removal and installation of a steering wheel
10:28. Removal and installation of assembly of the combined understeering switches
10:29. Removal and installation of the lock of ignition / blocking of a steering column
10:30. Removal, check of a state and installation of a steering column
10:31. Angles of installation of forward wheels
11. Body
12. Electric equipment
 







10-29-snyatie-i-ustanovka-zamka-zazhiganiya-blokirovki-rulevojj-kolonki.html

10:29. Removal and installation of the lock of ignition / blocking of a steering column

 PERFORMANCE ORDER

  1. Deactivate SRS (see the Head Elektrooborudovaniye).
  2. Remove the top and lower sections of a casing of a steering column.
  3. Disconnect an electrical wiring from the ignition switch.
  4. Tilt and accurately drill two fixing srezny bolts and remove assembly of the lock of ignition / blocking of a steering column.
  5. Establish assembly of the lock on a steering column — track that the pin of the lock got to a reciprocal opening in a steering column. After weak tightening of srezny bolts at the first stage of installation insert a key into the lock of ignition and check serviceability of functioning of the last, only after it tighten fixing bolts finally (before cutting of heads).
  6. Further installation is made as it should be, the return to an order of dismantle of components.
"on the page back
10:28. Removal and installation of assembly of the combined understeering switches		 on the following page"
10:30. Removal, check of a state and installation of a steering column